2013-10-22, 20:10
(2013-10-22, 16:01)stevenma61 Wrote:(2013-10-22, 14:00)pax Wrote: I tried 2 tipes of antenna, a wire and a copper stripe soldered to the GPS pins of the board.
I tried a very detailed gps.conf and Nokia supl servers (are google supl servers up ? )
but unfortunately I cannot solve my problem
I think that my faked firmware could be a problem...
Could it be a kernel or driver problem ? How could I investigate about it ?
One more question : to find the "right" ROM what compatibility can I assure (Baseband,Kernel version,Uboot build or LCD Driver IC ) ?
Thanks all !
the way i see
Wifi n GPS, actually share the same anttena
3G/2G share with one anttena
Wifi/GPS on top of the phone ( the 2 pins at the top left of yr picture)
3G/2G at the bottom of the phone. (3 pins)
try to make sure u have a good contact for the GPS/WIFI , the picture of yours, there is 2 pin on the left top corner, so make sure u have a good contact to the antenna ( anttena is some sort like a plastic patch(actually is a copper) at the top left hand corner, usually, u can see the wording GPS/WIFI written on it)
I have been disassembled my inew6000 for few times, the last time i had a difficult time to get a GPS locked, then i disassembled again, n make sure the contact is intact. then i get GPS locked in my house about 45 sec.
If the antenna is shared, I can find connections between pins with a tester. I'll test it !
I saw the connector and the stripes antennas under the cover, the contact seems good. Wifi is ok, the problem is only GPS. I'll try to verify the contacts again.
Why in Mobileuncle tools - Engineer mode - YGPS I can find : chip version and MNL version = unknown ? Hardware problem ?
I do not think to the information of this chinese faked firmware, I found on it everything (non-existing ram, model, logo, etc. )
Thanks again all !