2013-10-22, 16:01
(This post was last modified: 2013-10-22, 16:20 by stevenma61.)
(2013-10-22, 14:00)pax Wrote: I tried 2 tipes of antenna, a wire and a copper stripe soldered to the GPS pins of the board.
I tried a very detailed gps.conf and Nokia supl servers (are google supl servers up ? )
but unfortunately I cannot solve my problem
I think that my faked firmware could be a problem...
Could it be a kernel or driver problem ? How could I investigate about it ?
One more question : to find the "right" ROM what compatibility can I assure (Baseband,Kernel version,Uboot build or LCD Driver IC ) ?
Thanks all !
the way i see
Wifi n GPS, actually share the same anttena
3G/2G share with one anttena
Wifi/GPS on top of the phone ( the 2 pins at the top left of yr picture)
3G/2G at the bottom of the phone. (3 pins)
try to make sure u have a good contact for the GPS/WIFI , the picture of yours, there is 2 pin on the left top corner, so make sure u have a good contact to the antenna ( anttena is some sort like a plastic patch(actually is a copper) at the top left hand corner, usually, u can see the wording GPS/WIFI written on it)
I have been disassembled my inew6000 for few times, the last time i had a difficult time to get a GPS locked, then i disassembled again, n make sure the contact is intact. then i get GPS locked in my house about 45 sec.