Posts: 4
Threads: 1
Joined: 2015-06-28
Points:
62
Reputation: +4
Hello,
I have bricked my DG310 phone.
It does not boot at all, and when i connect my phone to usb it is connect for 3sec and disconnected. I'm using Win 7 64bit PC
plz help me thank you
You like this post
Posts: 360
Threads: 5
Joined: 2014-06-22
Points:
2,683
Reputation: +298
Sometimes when a phone is bricked like this, the incorrect driver will attempt to load. Not sure why its like that, by I've successfully flashed and bricked, then next flash couldn't flash until I switched drivers. Not saying that's the problem here.
Since you're on older SoC, you can try older versions SP Flash. That sometimes fixes the issue too.
You like this post
Posts: 4
Threads: 1
Joined: 2015-06-28
Points:
62
Reputation: +4
Hi again,
I tried your suggestions but still no luck.
The phone connects and disconnects after 3 seconds, the win 7 OS not pass the install driver process and end it after the device been disconnected.
I noticed that in the end I got "Alcatel Single RNDIS Interface" installed with the following hardware IDs: USB \ VID_0E8D & PID_0003 & REV_0100
any additional suggestions?
You like this post
Posts: 4
Threads: 1
Joined: 2015-06-28
Points:
62
Reputation: +4
Should I do it in the 3 seconds time frame, when the device connects and disconnects?
How do I know I found the right driver?
Will the device not be disconnected again after 3 seconds?
You like this post