![[-]](https://www.chinaphonearena.com/forum/images/collapse.png "[-]")
2017-04-27, 05:38
Hi,
I tried to make a port into myPhone Hammer Axe M LTE (which seems to be a rebranded Oinom LMV11H) - mt6752, Marshmallow 6.0. I took the stock ROM from and I took the TWRP for Lenovo K-50 (the same one used in the guide, as it seemed to fit). The porting was easy enough - brilliant tutorial! - flashing with SP Flash Tool was successful as well.
However: when I boot up my phone after flashing, holding the "Vol -" button, it boots into "Factory Mode" (it always does that even with stock recovery). But adb works in Factory Mode, so I "adb reboot recovery" which... reboots it into nothing. I just get a black screen. And after a minute or two the system normally boots up. The next "adb reboot recovery" gives me the stock recovery. I tried with two different versions of K-50 TWRP, they gave me the same result.
So I am wondering, did the port actually go wrong somehow and this just means that TWRP I built was corrupted? Should I maybe try with a different one, for a different device? Or is it my device's fault? That it cannot boot into recovery before it gets overwritten by the stock one? Or is it something else entirely? Has anyone experienced a similar issue?
My bootloader is locked and I cannot unlock it via fastboot, since my "Vol +" does not work in fastboot for some reason (which seems to be a common problem on some phones) so maybe it's that? But from what I read SP Flash Tool should work regardless of the bootloader lock...
Any ideas?
I tried to make a port into myPhone Hammer Axe M LTE (which seems to be a rebranded Oinom LMV11H) - mt6752, Marshmallow 6.0. I took the stock ROM from and I took the TWRP for Lenovo K-50 (the same one used in the guide, as it seemed to fit). The porting was easy enough - brilliant tutorial! - flashing with SP Flash Tool was successful as well.
However: when I boot up my phone after flashing, holding the "Vol -" button, it boots into "Factory Mode" (it always does that even with stock recovery). But adb works in Factory Mode, so I "adb reboot recovery" which... reboots it into nothing. I just get a black screen. And after a minute or two the system normally boots up. The next "adb reboot recovery" gives me the stock recovery. I tried with two different versions of K-50 TWRP, they gave me the same result.
So I am wondering, did the port actually go wrong somehow and this just means that TWRP I built was corrupted? Should I maybe try with a different one, for a different device? Or is it my device's fault? That it cannot boot into recovery before it gets overwritten by the stock one? Or is it something else entirely? Has anyone experienced a similar issue?
My bootloader is locked and I cannot unlock it via fastboot, since my "Vol +" does not work in fastboot for some reason (which seems to be a common problem on some phones) so maybe it's that? But from what I read SP Flash Tool should work regardless of the bootloader lock...
Any ideas?
