[Tutorial] HomTom HT3 Pro - LED BUG FIX - probable

[sshhuurraavvii]

The XP stock firmware version does NOT works on the old HT3 Pro.
OLD HT3 Pro = stock firmware version 1.0.9 / 1.1.2 / 1.1.3

Hello! I have Homtom HT3 Pro 1 revision (firmware 113 out of the box). Attempts to reduce the drain on the battery I got bootloop smartphone.
The Stock 113 firmware for Flash Tool can not be found (I wrote to Homtom support, but was told that this firmware they do not have). On the forum there were another forum 2 firmware, both at number 105, just GF20_HT3Pro_A_XP_VC_N40_V1.0.5_user_20161107-11_07_43 was less than 50 MB than GF20_HT3Pro_XP_VC_V1.0.5_user_20161105-11_37_06.
After flashing GF20_HT3Pro_A_XP_VC_N40_V1.0.5_user_20161107-11_07_43 smartphone will not start even (I tried 2 times a firmware update mode, and waited about 15 minutes). As it turned out this firmware for clone Homtom about XT3 smartphone ISPRIT U50LTE (the logo Venzo).
After flashing GF20_HT3Pro_XP_VC_V1.0.5_user_20161105-11_37_06 firmware (in firmware update mode), my smartphone has start and worked without any problems. It is strange that it did not go for Cleo.
Generally, you can flash any official (the others I have not tried) firmware revision to any revision smartphone (smartphone should be able to run), if the firmware flashing FlashTool uncheck points boot.img and lk.bin.
I put so firmware number 101 (2 revisions) and firmware GF20_HT3Pro_A_XP_VC_N40_V1.0.5_user_20161107-11_07_43 (for ISPRIT U50LTE). The most daring can try to make sure.
Good luck!