Rom for JLINKSZ k960

[firedrag]

hi marchefeu,
you are right, chipset is MT8321a, just a typing failure. This chipset is recognized as MT6580. I found now the right link between scatter files and Firmware. With the wiselink tool I can load the scatter file, where I see the linking and then create a new scatter txt file (notepad++) for SP Flash tool. Here I can Flash the different Firmware Version for testing.
I flashed accidently the preloader and had alwasy Enable DRAM failed! ERROR 4032. In this case you have to Flash a correct preloader. Mine was in the jlinks Image of K960_v3.0 vKB072L_GMS the M3 Preloader.
In the Attachement you find a scatter txt file for vKB005A which you can use in the SP Flash tool to Flash this Firmware.
I'm now back to bootloop and trying to find the right Firmware combination. K960_v3.0 vKB072L_GMS scatter file is broken, or I can't read it with wiselink tool.
Now I downloaded from jlinks the beTools which is similiar to the wiselink tool.
Here the scatter files .scr of the jlinks images work.

Hi Fire,
I have tested Betools available on jlinksz ftp. It seem recognize files available on this server but it status block at Detect Adevice...
I have dowload . key and install mtk drivers provide installed in his folder.
Perhaps you will luckier than me :-)

hi,
I use the Betools to load the scatter (.sca) file, so I know the file to partition linking, but then manually (Notepad) produce a txt scatter out of the .sca File to Flash it with the SP Flash Tool . Here everything works fine, I just need to format the flash sometimes. So I am sure the partitions setup is o.k. and that I load the correct files to the partitions.
I am on android screen, after startup, which is a progress. Keep you up to date if I sucess with one of the jlinks firmwares.