[Doogee Mix] Flashing Doogee Mix with SP Flash Tool

[GizBeat]

If you've tried flashing Doogee Mix with SP Flash Tool ROM, and got the error STATUS_BROM_CMD_SEND_DA_FAIL or any sort of BROM ERROR DA FAIL error, there is a simple solution.



With the phone off:

- Click DOWNLOAD in SP Flash Tool
- Hold VolumeUp on your phone
- Connect the phone while still holding VolumeUp
- Hold VolumeUp a couple of seconds after the red bar gets to 100%
- Release

The VCOM port should then trigger and begin the flash.

If you haven't installed the drivers yet, watch this YouTube

[vaggosdk]

If you've tried flashing Doogee Mix with SP Flash Tool ROM, and got the error STATUS_BROM_CMD_SEND_DA_FAIL or any sort of BROM ERROR DA FAIL error, there is a simple solution.



With the phone off:

- Click DOWNLOAD in SP Flash Tool
- Hold VolumeUp on your phone
- Connect the phone while still holding VolumeUp
- Hold VolumeUp a couple of seconds after the red bar gets to 100%
- Release

The VCOM port should then trigger and begin the flash.

If you haven't installed the drivers yet, watch this YouTube

tried this but still the same. now phone doesn't open. i saw a video on utube about how to fix this and i formatted. maybe i destroyed my doogee???