Posts: 48
Threads: 12
Joined: 2013-06-08
Points:
27
Reputation: +60
So the camera flash on my HX9299A (MTK6589) appears to be 'misfiring'.
Its not that it doesn't work, but the camera 'shutter' seems to open after the flash has fired (not at the same time).
The net effect is that the camera cannot take photos in the dark.
They all appear very dark.
Is there any way to change the flash/shutter timing?
Thanks.
You like this post
Posts: 3,182
Threads: 555
Joined: 2013-02-10
Points:
21,230
Reputation: +3637
Mobile flashes are generally pretty weak. Also, depending on the firmware, you may get a pre-flash for red-eye reduction. Can you post a picture of something relatively close up and show us what you're talking about regarding results?
You like this post
Two roads diverged in a yellow wood,
And sorry I could not travel both
And be one traveler, long I stood
And looked down one as far as I could
To where it bent in the undergrowth
Posts: 3,182
Threads: 555
Joined: 2013-02-10
Points:
21,230
Reputation: +3637
(2013-06-11, 21:47)MayhemVC Wrote: (2013-06-11, 21:23)Gizbeat Wrote: Mobile flashes are generally pretty weak. Also, depending on the firmware, you may get a pre-flash for red-eye reduction. Can you post a picture of something relatively close up and show us what you're talking about regarding results?
Sorry, tried to insert photos but I am apparently borderline retarded.
Will try again tomorrow.
Okay, try again. It was likely because the system hadn't promoted you to contributor yet.
Two roads diverged in a yellow wood,
And sorry I could not travel both
And be one traveler, long I stood
And looked down one as far as I could
To where it bent in the undergrowth
![[-]](https://www.chinaphonearena.com/forum/images/collapse.png "[-]")
