[ROM] Inew V3 official cxq 1.1.1

[kyllaz]

I think some devices are not compatible with this rom. I couldn't flash it. I'm using 1.0.8 GPS fix while waiting for the official one.

Also went back to 1.0.8, this one does not boot on my phone

[jo-the-ripper]

hi,
yesterday i flashed my inew v3 900mhz with 1.1.1 rom.

and it works!! it is because the new and different preloader. so for all 900 and 850 users you are free to flash this rom.

this is my method:
-download 1.1.1 [Only registered and activated users can see links Click here to register]
-flash back to 1.0.1 (i don't know if this is necessary)
-flash 1.1.1 with firmware->upgrade
-ignore error message
-after successful flashing go into recoverymode (reboot -> powerbutton+volumeupbutton)
-wipe(this help also if you hang in bootscreen)

greets
joe

[yo_jose]

I bought the V3 Inew at a local store, a franchise (in Spain), very good care and support.
The version that brings factory and v1.1.1 is and what I'm seeing is that the low battery too quickly, simply having the wifi enabled and automatic network selection, I have not fixed because being a MVNO (Ono) might ever runs out of coverage.

Main problem, the battery lasts very little. Otherwise, well, I have not yet tested the GPS.

[tywin]

I bought the V3 Inew at a local store, a franchise (in Spain), very good care and support.
The version that brings factory and v1.1.1 is and what I'm seeing is that the low battery too quickly, simply having the wifi enabled and automatic network selection, I have not fixed because being a MVNO (Ono) might ever runs out of coverage.

Main problem, the battery lasts very little. Otherwise, well, I have not yet tested the GPS.

Jose, have you considered buying a thl w8 battery?

[kyllaz]

Mine is this version WCDMA 850/2100 GSM 850/900/1800/1900MHZ v4.0, firmware instaled fine, no errors, but it doesn´t pass the logo in boot, so i think it does not work with all versions. I did not flash back to 1.0.1 but don´t think that´s necessary i also did not enter recovery mode and wiped, do you think that was my problem?

regards

[jo-the-ripper]

@kyllaz
Yes i had the same problem wirth booting. After the wipe my inew boot without problems.
Greets

[nosidefcp]

if it helps, the only way i found to flash this in the inew v3 was to first perform a full wipe/factory reset through cwm and then flash the 1.1.1 with download option ticked

[yo_jose]

I bought the V3 Inew at a local store, a franchise (in Spain), very good care and support.
The version that brings factory and v1.1.1 is and what I'm seeing is that the low battery too quickly, simply having the wifi enabled and automatic network selection, I have not fixed because being a MVNO (Ono) might ever runs out of coverage.

Main problem, the battery lasts very little. Otherwise, well, I have not yet tested the GPS.

Jose, have you considered buying a thl w8 battery?

No. I think a newly purchased mobile should not work so, it should work without a different battery (and without an external antenna to the GPS).
If a newly purchased phone, the battery does not last so you should, that battery is bad or the phone is not adjusted.
But we should not need a different battery, with a new phone.

[efex]

I cant install this rom :-(

My phone is version 4 but give me error in any flash tools v3 or v5.
Thats only happens with me ?

[faz844]

DOES THIS ROM WORK ?????