[Solved] Unbricking your V3 Plus V4.0

[tinker1980]

Hi guys,

I had the last 10 Hours tried to unbrick my INEW V3 PLUS V4.0 Modell.

First I had a total black phone, after an OTA Update was installed.
I have my phone not long, so I haven´t make a backup jet.

So the first thing ist to find the right Software for your Phone. In my case it was this image [Only registered and activated users can see links Click here to register]

I installed it, but it stucks in an bootloop. I tried many things, but finaly I found a poor but simple solution.

Power on your Phone, while holding Power Btn + Vol Down. Hold it until you see your Factory Mode... When you see the factory mode, simple navigate to Clear eMMC, if it is in chinease take a look at this pic..

Simply run this little proggy, and when all went fine, you are able to boot your Phone again.

[Exeleration-G]

Thank you, I'm sure this will come in handy in the future.