+- www.chinaphonearena.com (https://www.chinaphonearena.com/forum)
+-- Forum: Phone & Tablet Root, Hack and Develop (https://www.chinaphonearena.com/forum/Forum-Phone-Tablet-Root-Hack-and-Develop)
+--- Forum: *Tech support* General Phone & Tablet Root, Hack and Develop Root IMEI NVRAM CWM TWRP BRICKED (https://www.chinaphonearena.com/forum/Forum-Tech-support-General-Phone-Tablet-Root-Hack-and-Develop-Root-IMEI-NVRAM-CWM-TWRP-BRICKED)
+--- Thread: [Question] Help. I updated my Cubot X9, only to be locked in recovery mode (/Thread-Question-Help-I-updated-my-Cubot-X9-only-to-be-locked-in-recovery-mode)
Help. I updated my Cubot X9, only to be locked in recovery mode - globetrekker99 - 2015-12-06
Hello everybody. Yesterday, on December 4th, 2015, I installed an update for my Cubot X9. However, when I tapped install and accepted the reboot, the phone said there was an error and now it is only allowing me to use the "volume up" and "volume down" menu. I tried to reset to factory settings from the menu and then reboot the phone, but this didn't work. Unfortunately, I believe I know why this happened and that is because I had installed "KingRoot" into my device a few months before and did not know that rooting a device would make this happen. I didn't know it would "brick" my phone. Now I am just trying find a solution to the problem. However, I am a bit of a "noob" when it comes to technology and I would need step-by-step instructions on how to fix this. Please somebody, help me. Also it says "Android system recovery <3e>
CUBOT_4271C_z61W5_V20
RE: Help. I updated my Cubot X9, only to be locked in recovery mode - deanlee121 - 2015-12-06
Flash a new rom on it
Go here
RE: Help. I updated my Cubot X9, only to be locked in recovery mode - cookiedough - 2015-12-06
Yes, you will need to flash a new ROM. Probably through PC, unless Cubot offers full SD install ROM, but I doubt that. So you will probably need to use flashtool.