Posts: 3,182
Threads: 555
Joined: 2013-02-10
Points:
21,230
Reputation: +3636
Standard disclaimer applies. Make mods to your phone at your own risk. Cheers
The "Wind" ROM.
- Fixes power display accuracy
- Status Bar 50% Transparent
- HDR Camera - Must set to 8mp or lower to work properly
- Pre-Rooted
[Only registered and activated users can see links Click here to register]
[Only registered and activated users can see links Click here to register]
You and
iakinthos like this post
Two roads diverged in a yellow wood,
And sorry I could not travel both
And be one traveler, long I stood
And looked down one as far as I could
To where it bent in the undergrowth
Posts: 3,182
Threads: 555
Joined: 2013-02-10
Points:
21,230
Reputation: +3636
This ROM installed fine. It's the ROM I'll be using for now along with CWM, 2.5GB partition mod and 4.2 camera.
You like this post
Two roads diverged in a yellow wood,
And sorry I could not travel both
And be one traveler, long I stood
And looked down one as far as I could
To where it bent in the undergrowth
Posts: 100
Threads: 2
Joined: 2013-03-22
Points:
127
Reputation: +113
What is partition size of internal sd card with this firmware? full wipe before installing? userdata will be replaced? 3G and WLAN working correctly?
You like this post
ZP990 2/32 MT6589T | PS7 2/16 MT6592
Posts: 3,182
Threads: 555
Joined: 2013-02-10
Points:
21,230
Reputation: +3636
My WLAN and H / H+ always worked flawlessly. Regardless of ROM.Anyways, I believe the 3G patch is a baseband patch, not a ROM patch. Wind ROM is the best if you want to be on 4.1.2. But some people like Jumpy Zopo.
Not sure about EBR. I think stock EBR. Can replace with whichever EBR you need before flashing.
You and
ChrisX like this post
Two roads diverged in a yellow wood,
And sorry I could not travel both
And be one traveler, long I stood
And looked down one as far as I could
To where it bent in the undergrowth
Posts: 100
Threads: 2
Joined: 2013-03-22
Points:
127
Reputation: +113
i`ve tried 2 ROMs ... first this "Wind" ROM and it works absolutely fine! The transparent statusbar looks very nice. Scrolling is very smooth.
Then i was curious and flashed the Gizbeat Combo 4.2.1 ... and sure i will go back to 4.1.2!
You realize that it is beta ROM, i permanently must login again into appshop and scrolling is not liquid! Move widgets on homescreen, write with the keyboard ... all very jerky!
Now my question ...
I`ve never done before a downgrade, is it possible to flash the "Wind" ROM over the 4.2.1 ROM with full wipes?
Or must i flash stock ROM 4.1.2 before i flash Wind with CWM? What about the 3G partition size, is it preserved?
You like this post
ZP990 2/32 MT6589T | PS7 2/16 MT6592
Posts: 3,182
Threads: 555
Joined: 2013-02-10
Points:
21,230
Reputation: +3636
Just reflash Wind.
I have none of what you experience on 4.2.1 Chris. I'm running 100% flawlessly on 4.2.1. Zero bugs.
You like this post
Two roads diverged in a yellow wood,
And sorry I could not travel both
And be one traveler, long I stood
And looked down one as far as I could
To where it bent in the undergrowth
Posts: 100
Threads: 2
Joined: 2013-03-22
Points:
127
Reputation: +113
(2013-04-09, 14:45)Gizbeat Wrote: Just reflash Wind.
ok, i`ll try it this evening. is it sufficient to wipe before flashing?
because its downgrade ...
(2013-04-09, 14:45)Gizbeat Wrote: I have none of what you experience on 4.2.1 Chris. I'm running 100% flawlessly on 4.2.1. Zero bugs.
don`t know why. it was clean install.
You like this post
ZP990 2/32 MT6589T | PS7 2/16 MT6592
Posts: 3,182
Threads: 555
Joined: 2013-02-10
Points:
21,230
Reputation: +3636
No need to wipe before. If I remember correctly, it's a full ROM. It should write over everything. Format internal storage after, especially if different EBR than previous ROM. Usually I wipe dalvik and cache after flash too. But it's arguable how necessary this is.
You like this post
Two roads diverged in a yellow wood,
And sorry I could not travel both
And be one traveler, long I stood
And looked down one as far as I could
To where it bent in the undergrowth
![[-]](https://www.chinaphonearena.com/forum/images/collapse.png "[-]")
